Formula Center
Build sliding / window / door recipes once; Create Assembly applies W, H, and panel qty.
Import hardware groups
Import a Formula Center group, then mark items and Apply to the unit.
Imported (staging)
Applied to this unit
Items listed under their group. These lines go to the assembly list.
Bill of materials
Full assembly list for this position.
Mark plan or vertical cuts on the elevation where a section is required, then press Finish to save. Use Export DWG / Save PDF for drawings, or Close if you only opened this unit to review.
Sliding panel elevation
Unit plan follows this positionโs shutter count. Frame, stile, head and sill details come from the common 4-panel division on Assembly Data (HS-L ยท IS-R ยท IS-R ยท FX-R) โ click a shutter only to change its type.
Layout: frame elevation only. Profile joints appear on Profiles & Details. Full drawings on Review.
Elevation ยท Exterior (outside)
Project sections
Click the elevation to mark where a section is required. No default cut lines.
Vertical section ยท mark a cut to generate
Plan section ยท mark a cut to generate
Plan ยท tracks
Layout
โ
Create Assembly
Frame
Select profile numbers
Same profile on all sides, or different numbers for Left / Right / Top / Bottom.
100%
Assembly Data
Choose elevation
Click an elevation to use it, then Generate Assembly List.
New unit
Create Assembly
Set the unit on the left. Pick the elevation under its type on the right.
If only one subsystem exists for this brand and typology, it is selected automatically.
Collected from project Approved Finish Colors. If none is entered, RAL is used.
Choose Standard, Reverse, Meeting, Corner or Pocket. Only that sliding layout is shown.
Structural check
Proceed anyway
Select a reason, then pick the interlock manually. Structural capacity is not re-checked.
Reason *
Profiles from the current Interlock DB for this system.
Elevation
Select interlocks
Choose each half of the meeting pair. Connected sets such as 4542+4544 are picked as two cells, then OK.
Codes come from Interlock DB for this system. First cell then second cell, then OK. Structural calculation is not used.
Layout
Sash position
Fixed / slide left / slide right, and which track each leaf sits on. FX-L + IS-R and FX-R + IS-L are not allowed. Use FX-L + IS-L or FX-R + IS-R.
Master leaf
Profile system
Select brand & system
Choose brand, then typology, then the elevation for this unit.
Typology
Elevation
Elevation
Unit
Unit information
Enter the position code and overall size. These values appear on drawings and the assembly list.
Opening